Jump to content

320touring's Elgrand.. tyred and Hired (not really, just on loan) 15/05/23


320touring

Recommended Posts

  • 320touring changed the title to 320touring's Elgrand.. Dave_Q's got the key, he's got the Secret... 13/02/23
15 hours ago, 320touring said:

For a paltry sum, our very own @Dave_QĀ made me a new key from a PICTURE of the old one. He supplied the blank, cut it and posted it up first class too.

Ā 

top service, well pleasedšŸ‘

Ā 

It'd be great if you could show us a photo of the new key, m8.

Link to comment
Share on other sites

  • 320touring changed the title to 320touring's Elgrand.. First full tank MPG.. who won? 16/02/23
On 04/02/2023 at 10:39, Forty45 said:

23mpg

Ā 

On 04/02/2023 at 10:46, Lanciaman said:

19.7 mpg

Ā 

On 04/02/2023 at 11:28, aldo135 said:

24.5 mpg. Watching with interest Neil, I like these šŸ™‚

Ā 

On 04/02/2023 at 12:29, Jim Bell said:

27.6 mpg

Ā 

On 04/02/2023 at 12:40, Back_For_More said:

21.4mpg...... Traffic jams not withstandingĀ 

Ā 

On 04/02/2023 at 12:49, DVee8 said:

18.6 mpg

Ā 

On 04/02/2023 at 13:00, Popsicle said:

19.9 mpg

Ā 

On 04/02/2023 at 13:13, hairnet said:

less than 25 more than 20

Ā 

Ā 

On 04/02/2023 at 14:54, barefoot said:

I reckon it'll manage just theĀ right side of 20Ā - so that's 20.1 mpg from the barefoot judge.

Ā 

On 04/02/2023 at 15:58, Dave_Q said:

28.7mpg. On the high side but I reckon you can do it with a bit of effort.

Ā 

On 04/02/2023 at 19:14, HillmanImp said:

My 3.5 e51 did 17mpg on the motorway with 3 of us, our camping equipment, bikes and my driving.Ā 

Genuinely would've been cheaper to stay in a fancy hotel than go away that evening.Ā 

Whatever it is, I know its bad.Ā 

Ā 

On 04/02/2023 at 19:20, Stanky said:

Benchmark: Set.

based on this insider knowledge, 16.6 MPG from me.

And genuine apologies if I am anywhere remotely close to being right!

Apologies for the delay...

Ā 

The results are finally in..

Ā 

660.3km (410.3miles) covered, 75L of fuel consumed.Ā 

Total cost Ā£105.52

That's 25.7p/mile.

Ā 

And 24.87 MPG.

Ā 

on that basis, congratulations to @aldo135Ā with his guess of 24.5MPG

Honourable mentions toĀ 

@Forty45Ā for his guess of 23mpg, and to @hairnetĀ for his brilliantly precise "less than 25, more than 20"

Ā 

I don't think that's the worst, although I'm mildly perturbed that the fuel light didn't come on despite the needle being well into the E..

Link to comment
Share on other sites

  • 320touring changed the title to 320touring's Elgrand.. Seeing the light, and becoming Less Holy 17/02/23

The passenger dipped beam has been out since I got the van...

Hmm

IMG_20230217_175343480_072346.thumb.jpg.cceac2ea75cadbb4bfcae13cc28fffc0.jpg

Wonder what caused that?

IMG_20230217_102214140_HDR_111240.thumb.jpg.3996fcccebf05058546c611d3954bc65.jpg

Yep, that's fucked.

Cut back to good wires

IMG_20230217_102911322_111238.thumb.jpg.45b64d8d5fe26adf089484db667f4910.jpg

Applied a wee bit of new loom and connector

IMG_20230217_111131852_111231.thumb.jpg.f6482ddc1b63aa4718f06da2b8ae5286.jpg

Ā 

Happily this was a great success!

IMG_20230217_110738475_HDR_111235.thumb.jpg.ca23163b9fe40242a422dd71e56c68be.jpg

Ā 

The drive home was significantly more illuminating than the last night time run.

Link to comment
Share on other sites

As seems to be par for the course for old jap scrap, this Elgrand is not without its Elgrot..

The back of the rear wheel arches are a classic mud trap - especially with the mudflaps.

Passenger side

IMG_20230217_131925731_HDR_030403.thumb.jpg.2cc76b4f0c5254658f3a32578ea2200b.jpgIMG_20230217_132116043_030253.thumb.jpg.b6badd457588b8b0eabead0dd400687b.jpgIMG_20230217_132144312_030224.thumb.jpg.34b04ee37852733823a11fe375e4f524.jpg

IMG_20230217_132424885_030129.thumb.jpg.509e4e78c86d68fb090a45db71bb0342.jpg

As you can see, I wasn't kidding...

Then it was time to tidy it up

IMG_20230217_132342567_030203.thumb.jpg.a251818234b67c2c55742ffff0a7dd7c.jpg

IMG_20230217_134204811_030013.thumb.jpg.89f8ab1102d449da6b63c9900163f491.jpg

IMG_20230217_134148768_030047.thumb.jpg.e33710eb97efcc1b1c0ade6242813992.jpg

IMG_20230217_133329423_030106.thumb.jpg.1a1c5210f9736b64d67104843f66225c.jpg

IMG_20230217_134552840_025953.thumb.jpg.b7f8b120b48ea5ef2f582710392d848a.jpg

The outer panel was actually reasonably solid. With only a small patch on the lip required.

Ā 

The inner panel...ehh, not so much..

IMG_20230217_134939797_HDR_025936.thumb.jpg.5dd56ac0ca4e51574e833eb4222858d3.jpg

IMG_20230217_134952205_025858.thumb.jpg.9a89a38362ee6cbcb3a2ac51ce952116.jpg

IMG_20230217_135749728_025833.thumb.jpg.a6b354ec3275377eec62371355f6c021.jpg

IMG_20230217_144406604_HDR_025811.thumb.jpg.ba8487a1b44054be450475cbc463c128.jpg

Now, it's not perfect (and the last picture was taken before it was completely welded)

But by Christ, it's a lot better!

Ā 

Link to comment
Share on other sites

The drivers side was pretty damn bad, and constituted the 'lightness' @aldo135Ā mentions below..

On 16/02/2023 at 21:16, aldo135 said:

Thatā€™s good going! Maybe helped by the added lightness it benefits from :)Ā 

IMG_20230217_161202124_072353.thumb.jpg.0b3372077d672e74241faae31dd22faf.jpgIMG_20230217_152448414_072355.thumb.jpg.9d7c4545378301da3f9d0ea4a127ea0b.jpg

it was wire brushed back, and cut to decent metal.

The inner patch was tacked in, then the welder ran out of gas.. additionally, I can see that there is another wee hole needing a patch ..

IMG_20230217_171403726_072350.thumb.jpg.dd71c1ca493f710b99a9213416f92f2d.jpg

Good news is that the inner panel and return gives a good basis for building the outer one up.

I'll likely put one panel horizontal along the bottom, then weld a vertical one to follow the curve of the panel.

1708092404_IMG_20230217_1713434852_073138.thumb.jpg.cfe4826ccacd8d3cdaf8af36a49ece1d.jpg

Ā 

Time to get more gas then!Ā 

I bet @GingerNuttz is glad I didn't ask himšŸ¤£šŸ¤£

Link to comment
Share on other sites

16 hours ago, 320touring said:

The drivers side was pretty damn bad, and constituted the 'lightness' @aldo135Ā mentions below..

IMG_20230217_161202124_072353.thumb.jpg.0b3372077d672e74241faae31dd22faf.jpgIMG_20230217_152448414_072355.thumb.jpg.9d7c4545378301da3f9d0ea4a127ea0b.jpg

it was wire brushed back, and cut to decent metal.

The inner patch was tacked in, then the welder ran out of gas.. additionally, I can see that there is another wee hole needing a patch ..

IMG_20230217_171403726_072350.thumb.jpg.dd71c1ca493f710b99a9213416f92f2d.jpg

Good news is that the inner panel and return gives a good basis for building the outer one up.

I'll likely put one panel horizontal along the bottom, then weld a vertical one to follow the curve of the panel.

1708092404_IMG_20230217_1713434852_073138.thumb.jpg.cfe4826ccacd8d3cdaf8af36a49ece1d.jpg

Ā 

Time to get more gas then!Ā 

I bet @GingerNuttz is glad I didn't ask himšŸ¤£šŸ¤£

Good work mate. It deserves the attention for all the economy itā€™s giving!Ā 

Link to comment
Share on other sites

On 2/16/2023 at 7:06 PM, 320touring said:

Ā 

Ā 

Ā 

Ā 

Ā 

Ā 

Ā 

Ā 

Ā 

Ā 

Ā 

Ā 

Ā 

I don't think that's the worst, although I'm mildly perturbed that the fuel light didn't come on despite the needle being well into the E..

Fuel gauges on these almost always seem to be suspectā€¦. Mine lied like a politicianĀ 

Link to comment
Share on other sites

  • 2 weeks later...
  • 320touring changed the title to 320touring's Elgrand.. Smoother than Trevor Nelson (C) SDKRC 14/03/23

Third tank in, even though it was a bit of a short fill (car doing long run tomorrow so wanted it topped up this evening).

Ā 

Ā 

Ā 

471km covered, Ā£78 used at 1.397 @ litre.

23.83mpg..

It's not moving about too much, and this tank had more town work than normal...

34p a mile in fuel for the last 1000 miles ..

Link to comment
Share on other sites

  • 320touring changed the title to 320touring's Elgrand.. What sorcery is this?17/03/23

@stereotypeĀ has the Elgrand this weekend, so I decided to do the old 'once over check'

As @jaypeeĀ noted on the way home from the unit on Wednesday, the top right rear light was out .

two 10mm bolts releases the light, and the bulb holder twists out.

An odd bulb type for me ( not being a JDM man)

IMG_20230317_094310474.thumb.jpg.abfd0ee16450a74cee5b05cbab86433f.jpg

Ā 

Apparently a 580...

Something new learned today.Ā  #doublefilamentnaebayonet

JDMSKILLZ BRO!

Ā 

anyway, all fitted and good.

Link to comment
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...