catsinthewelder Posted March 12, 2022 Posted March 12, 2022 @Zelandeth I'm going to make a small fuel tank to gravity feed the carb between now and the FoD then see if it'll run with the CDi from the black one. It's lost all its lights for some reason so I was thinking of using the headlight switch as an ignition switch being as the scooters all go to bed before dark at the FoD for noise reasons. For that reason I was thinking of bringing the electric bike/scooter down as a silent bog run bike (once someone more talented than me has fixed it). Thanks @Six-cylinder Six-cylinder 1
Snake Charmer Posted March 13, 2022 Posted March 13, 2022 21 hours ago, wuvvum said: Where were you planning on sitting? On a new set of frame rails with all the rear junk and original rails removed. I also planned to move the shock in front of the engine operated via a rocker arm or just an arm. Fuel and oil tanks under the GRP tank with electrics and radiator. Cafe racer up top, Scooter below and a shopping basket where the footboards were for beer. Six-cylinder 1
Six-cylinder Posted March 13, 2022 Author Posted March 13, 2022 Todays project was to replace the brake disk on my Peugeot 504 that I slid down the road on when the wheel fell off! @Andyrew came over to help me and all was going well until we went to put the pads back in and found one of the pistons would not push in. We tried using the brakes thinking if we got it moving then we could work it, but the piston would not come out either. The new disk is 1 mm thicker than the old one so we needed to push the piston back. The Piston is now off the car and Andyrew has taken it home to see if he can free it up. dozeydustman, Dyslexic Viking, Mrs6C and 4 others 7
Six-cylinder Posted March 13, 2022 Author Posted March 13, 2022 59 minutes ago, richardmorris said: Did you have a pad winder tool thingy? Do these wind back?
hairnet Posted March 13, 2022 Posted March 13, 2022 3 hours ago, Six-cylinder said: PHWOOOARRRRRRRRR (and the car )
hairnet Posted March 13, 2022 Posted March 13, 2022 35 minutes ago, Six-cylinder said: Do these wind back?
Talbot Posted March 14, 2022 Posted March 14, 2022 12 hours ago, Six-cylinder said: Do these wind back? No. You can tell if they need turning at the same time, as the piston will have a cutout notch in it which locates in a tab on the brake pad, stopping it from turning in normal service. If you've stood on the brakes as hard as possible and the piston still won't move, you're looking at needing a new piston and a caliper refurb kit as a bare minimum... that's if you can get the old piston out somehow. Heat sometimes helps. As does a 20T press.... Six-cylinder 1
2cvspecial Posted March 14, 2022 Posted March 14, 2022 On 3/8/2022 at 6:10 PM, Six-cylinder said: I am hoping to get an electric Fiat 500 for 3 day. Claimed range 199 miles so it will be interesting to compare. a relative has one , I liked it -# Six-cylinder 1
AxWomble Posted March 14, 2022 Posted March 14, 2022 @Six-cylinder - I swore that after missing all the FoD events last year, I’d make my debut at the first opportunity in 2022 - MissAxWomble was all in favour too! Alas, we’re getting married on the 26th, and generous though she is, I think that would be a step too far 😂😂😂 2cvspecial, Six-cylinder, chaseracer and 2 others 3 2
Dobloseven Posted March 14, 2022 Posted March 14, 2022 27 minutes ago, AxWomble said: @Six-cylinder - I swore that after missing all the FoD events last year, I’d make my debut at the first opportunity in 2022 - MissAxWomble was all in favour too! Alas, we’re getting married on the 26th, and generous though she is, I think that would be a step too far 😂😂😂 Hope you're going to have suitably Autoshite wedding cars! Six-cylinder 1
High Jetter Posted March 14, 2022 Posted March 14, 2022 47 minutes ago, AxWomble said: @Six-cylinder - I swore that after missing all the FoD events last year, I’d make my debut at the first opportunity in 2022 - MissAxWomble was all in favour too! Alas, we’re getting married on the 26th, and generous though she is, I think that would be a step too far 😂😂😂 Surely the FOD would be an ideal* place to spend your honeymoon? If you'd given more notice, the six-cylinders might have been able to get the field registered for ceremonies. Six-cylinder and chaseracer 1 1
AxWomble Posted March 14, 2022 Posted March 14, 2022 4 hours ago, Dobloseven said: Hope you're going to have suitably Autoshite wedding cars! I’m travelling in *style in our silver 106 diesel, she is arriving in her dad’s teal-blue MGB GT. We’re departing in our car, complete with ribbons, tins, and whatever rubbish our friends find in the recycling bin that morning….. Yoss, EightMegs, MondeoBlues and 1 other 4
AxWomble Posted March 14, 2022 Posted March 14, 2022 4 hours ago, High Jetter said: Surely the FOD would be an ideal* place to spend your honeymoon? If you'd given more notice, the six-cylinders might have been able to get the field registered for ceremonies. She says that Devon is still preferable! 2cvspecial and Six-cylinder 2
AxWomble Posted March 14, 2022 Posted March 14, 2022 Unbelievably, she has just asked me what time events close on the Sunday, as we aren’t actually going on honeymoon till the following Saturday and don’t have any plans!? Not sure where I found her but hey, this is a good sign! wesacosa, Craig the Princess, catsinthewelder and 7 others 10
DVee8 Posted March 14, 2022 Posted March 14, 2022 5 hours ago, High Jetter said: Surely the FOD would be an ideal* place to spend your honeymoon? If you'd given more notice, the six-cylinders might have been able to get the field registered for ceremonies. MrsV8 is a Wedding celebrant. Six-cylinder 1
richardmorris Posted March 14, 2022 Posted March 14, 2022 2 minutes ago, DVee8 said: MrsV8 is a Wedding celebrant. Perfect, there’s even honeymoon accommodation with the caravan and en-suite bog. Six-cylinder and chaseracer 2
High Jetter Posted March 14, 2022 Posted March 14, 2022 53 minutes ago, AxWomble said: Unbelievably, she has just asked me what time events close on the Sunday, as we aren’t actually going on honeymoon till the following Saturday and don’t have any plans!? Not sure where I found her but hey, this is a good sign! I'll have a couple of randoms, if it ever goes that way! wuvvum, AxWomble, Talbot and 1 other 4
Crackers Posted March 14, 2022 Posted March 14, 2022 25 minutes ago, DVee8 said: MrsV8 is a Wedding celebrant. I'm sure AS must have enough musicians on here to form a decent wedding band, too. I think something's coming together here lads! chaseracer, AxWomble and Six-cylinder 3
richardmorris Posted March 14, 2022 Posted March 14, 2022 Just now, Crackers said: I'm sure AS must have enough musicians on here to form a decent wedding band, too. I think something's coming together here lads! I have white ribbons for the 2cv too. AxWomble 1
Crackers Posted March 14, 2022 Posted March 14, 2022 1 minute ago, richardmorris said: @RichardK has white ribbons for the Tavria too. EFA. I don't think a 2CV is shite enough for an AS wedding! 2cvspecial and AxWomble 2
richardmorris Posted March 14, 2022 Posted March 14, 2022 Just now, Crackers said: EFA. I don't think a 2CV is shite enough for an AS wedding! What about the allegro VDP? LightBulbFun 1
AxWomble Posted March 14, 2022 Posted March 14, 2022 15 minutes ago, richardmorris said: You arranged all that a darn side quicker than we managed it all - I’ll get on the beige phone to the caterers, band, church and photographer and ask if we can have all our money back - surely they’ll all have a 15 month cooling off period? 😂😂😂😂 richardmorris and Dobloseven 2
AxWomble Posted March 14, 2022 Posted March 14, 2022 21 minutes ago, Crackers said: EFA. I don't think a 2CV is shite enough for an AS wedding! I’m planning on tarting up the 106’s wheels for the occasion, binning the plastic wheel trims in favour of some silver rattle can work and black centre caps. Still suitably AS I reckon!
Dobloseven Posted March 14, 2022 Posted March 14, 2022 That long wheelbase Mercedes that Zelandeth decided against, would make a good wedding car. Marquee and mobile fish and chip van,ice cream van, ideally a Perkins powered CF for pudding, job's a good un! LightBulbFun and richardmorris 2
richardmorris Posted March 14, 2022 Posted March 14, 2022 43 minutes ago, AxWomble said: You arranged all that a darn side quicker than we managed it all - I’ll get on the beige phone to the caterers, band, church and photographer and ask if we can have all our money back - surely they’ll all have a 15 month cooling off period? 😂😂😂😂 I’ve done a few weddings now with the 2cv and it’s both fun and an enormous pain.
Snake Charmer Posted March 14, 2022 Posted March 14, 2022 22 hours ago, Six-cylinder said: Do these wind back? The rears have to be treated very delicately as the ratchets mechanisms are not available. With the pads removed, the piston has to be turned 45° to push it back then turned 45° to re-engage the ratchet. I rebuilt a set recently, they are also fitted to De Tomaso and AC Cobra MkIV. Mrs6C 1
Six-cylinder Posted March 14, 2022 Author Posted March 14, 2022 20 minutes ago, Snake Charmer said: The rears have to be treated very delicately as the ratchets mechanisms are not available. With the pads removed, the piston has to be turned 45° to push it back then turned 45° to re-engage the ratchet. I rebuilt a set recently, they are also fitted to De Tomaso and AC Cobra MkIV. Is that to do with the handbrake?
richardmorris Posted March 14, 2022 Posted March 14, 2022 23 hours ago, Six-cylinder said: Do these wind back? I thought all discs pads did? ( I know nothing and is the reason I pay someone else)
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now