Jump to content

VW Sharan tdi - time to say goodbye


Recommended Posts

Posted

I cleared the fault codes yesterday so I've just done them again bearing in mind it went into limp mode once.

 

I have p1156 which is something to do with the map sensor. Also p1161 and p1557 which I haven't looked up yet

Posted

All 3 codes are MAP sensor related, open or short to ground.

 

Have you unplugged the MAP when poking about?

 

Sorry I don't know where the MAP is located on this engine, probably on the inlet manifold or intake somewhere.

 

Worth giving it a clean with brake cleaner, and also check the wiring.

Posted

All 3 codes are MAP sensor related, open or short to ground.

 

Have you unplugged the MAP when poking about?

 

Sorry I don't know where the MAP is located on this engine, probably on the inlet manifold or intake somewhere.

 

Worth giving it a clean with brake cleaner, and also check the wiring.

Thanks, I had the map sensor unplugged but not with the engine running. I cleaned it too with some degreaser as I didn't have any carb cleaner. I've cleared the code. If it comes back I might just get a new sensor as they're not expensive.

Posted

I got quite a bit done today. Touched up a couple of small rusty areas on the inside edges of the sills. Changed the oil and filter. The old oil looked quite dirty. Fixed the aerial which is on the back window as the clip had come off. Took off the parking sensor I think is at fault and ordered a new one. Tried to change the pollen filter but couldn't get the wiper arms off so ordered a small puller. Some more Mr muscle in the turbo. Lots of burns as it ran down my arms, nasty stuff.

 

Went for another drive and marvelled at how clever the gearbox is. If you put it in manual mode and select a gear it will override you as you slow down and also change up if the revs get too high. Very clever. It seems to change quite smoothly although the lever can need a good pull at certain times.

 

I've still got a slight coolant leak from the hose that goes to the egr. Can anyone tell me how I can identify which hose it is? Might need to go the dealer I think.

  • Like 3
Posted

What do you mean? Your not sure where it's leaking or you need part no?

Sorry, I know which hose but I want to try and find the part number so I can order one.

Posted

Thanks for the help. I've had a read through those sites and others. I think it might be no.2 on the diagram Krujoe provided but as I'm not 100% I might call in at the VW garage and see if they have it. The tape i used has started to come undone due to the heat.

Posted

cut pipe insert piece of copper pipe tighten with jubilee clips job done

Posted

cut pipe insert piece of copper pipe tighten with jubilee clips job done

That does sound a good solution! I was trying to work out how to do it. Will give that a try first.

Posted

That does sound a good solution! I was trying to work out how to do it. Will give that a try first.

 

my B-I-L used to carry a 4 inch length of copper just in case a customer needed a temp fix for knackered heater matrix

Posted

^That diagram is a pre-PD TDI, if it's not the same try http://www.oemepc.com/ for yours.

Yeah it pre pd, its also possibly american version of engine, cos i don't think any uk ve style motors got the egr cooler, but could be talking bollox. Deffo check the number on the site Dave Q suggests, its a good site, and same as what the dealers use.

Posted

Yep, that was just an example of a coolant system component diagram - I didn't put much effort into finding the correct one for this car.

That pipe in the ebay link looks the same size at both ends, so any Shiter with a good hoard of random tat should have a bit of pipe to do the job. Does it really need all those kinks and bends just so?

But if the break is not near an end of it, then I agree - put a length of metal pipe inside with hose clips.

£almost_free_fix FTW.

  • Like 1
Posted

A quick update on this...

 

I've been using it for the last couple of days including a good 50 miles of motorway and no limp mode! It does seem to smoke a bit when you first set off but not too bad. I used Mr muscle in the egr and exhaust side of the turbo but that's not as good as getting it right into the heart of the turbo which failed me. I've also used some turbo cleaner and injector cleaner.

 

It's taught me about vcds and fault codes though which is a bonus. No faults for the engine at the moment. I managed to find out which parking sensor was faulty and ordered a new one for £8. Put that on tonight and working parking sensors! They make a big difference as I have to parallel park on our street.

 

Managed to locate the correct egr hose from trade parts specialists in Leicester. I went to the VW garage first and they told me they don't do spare parts anymore so sent me to TPS. They're not cheap though. The hose was £31 and I asked for a quote for pads and discs for the front, £208!

 

I'm enjoying driving this. Love the high up driving position and the space. The family love it too. Very relaxing to drive. Averaging about 35mpg around the doors so expect 40ish on a run which isn't too bad as it's quite heavy and the autobox probably doesn't help. It needs a good long run before I declare a victory on the limp mode though.

Posted

Sounds positive - fingers crossed for you!

How much have you spent getting it to this stage?

  • Like 1
Posted

Sounds positive - fingers crossed for you!

How much have you spent getting it to this stage?

The various turbo cleaning products, service items, parking sensor, hose and a few other bits, around £120 so not bad at all. Just front brakes to sort now and then might treat it to some car mats! The tyre's staying up too although had to change the battery, but luckily had a spare one.

Posted

Just to add, I had a near miss today. Forgot I was driving an automatic and stamped on the brake pedal with my left foot thinking it was the clutch. Nearly got rear ended by a transit! Need to watch that.

  • Like 1
Posted

Aye, we've all been there!

You need to forget you have a left leg and keep it planted on its foot rest.

  • Like 2
Posted

Yep, manual To auto is fun, I went for the clutch pedal yesterday despite having the gooner for 2 weeks, and still go for the gear lever before remembering and just sort of stroking the shifter for a few seconds...

 

Its the weekend tomorrow, ecp will have a 30% sale on...

  • Like 2
Posted

I did the old Mr Muscle trick on a pre-PD B5 Audi I had a while back. It pulled like a train and never went into limp mode again. EGR bolts were a bitch though iirc.

It's a common, cheap and effective fix when the turbo vanes are layered in crap.

Glad it seems to have worked for you!

  • Like 1
Posted

 

Its the weekend tomorrow, ecp will have a 30% sale on...

 

 

Fuck that, get on GSF! That's if you can cope with delivery only. They're mega cheap at the weekends.

  • Like 3
Posted

I now find it hard going from auto to manual, rather than the other way around that happened at first. I forget to clutch, especially when having to come to a quick stop!

 

I found putting my left foot under the brake pedal much better. That way when I come to lift my foot, it hits the bottom of the pedal reminding me that I'm doing it wrong.

Posted

I drove the wife's beetle earlier. I was just about to start it with my foot on the brake as I do in the sharan. It was in gear too. I bet a few accidents are caused by this.

  • 3 weeks later...
Posted

Quick update on this. I really like it! It's ideal for family duties. We're currently away on holiday in it. I like the way you can configure the seats just how you want them so, for example, I took 3 of them out for our holiday to give lots of space for luggage, kids bikes etc. Put a gap between the kids so they can't fall out (didn't work). It also proved useful fully loaded with topsoil and turf last weekend. Handled that very well with all the seats out.

 

I've only had the limp mode once in the last 1000 miles, at the end of a long motorway journey. Turned it off and on again and it was then fine. I've still got some turbo cleaner to run through it, Archoil 6400D-Max, which has good reviews.

 

There's no spare wheel but I wasn't worried as not had a puncture in years. Guess what, I had a puncture. I had to drive 5 miles home which trashed the tyre. Picked up a partworn for £30 which will do for now but it's not the right load rating. Needs to be 'extra load' apparently, 97, and it's a 93. I'll get a couple of new tyres on it when funds allow.

 

I've done a few jobs on it including a service, tidied up some surface rust on the wheel arches, fixed a door handle, some spray underseal on a couple of places underneath. It's been waxoyled though so all quite good underneath. I also made myself some temporary mats out of some old carpet like a proper giffer.

 

It's no rocket ship and pressing the accelerator to the floor just makes more noise and the mpg reading to plummet. There's also no hiding it's bulk in the corners as it likes to understeer. I've changed my driving style to suit. Much nicer to cruise along at 65/70 and use the accelerator gently which encourages it to change up sooner. I've been getting 42mpg max and down to 35 in traffic which I'm pleased with.

 

Other things I like are the electric tilt windows you control from the front which help with getting airflow through the car, and the parking sensors which I've never had on a car before but are great especially on something this big when I need to do a lot of street parking.

 

It's the highest mileage car I've owned at 203k but it drives really well and I can see myself keeping it for a while

post-19517-0-51461500-1492637781_thumb.jpg

post-19517-0-27765700-1492638174_thumb.jpg

Posted

YES to the beige mats!

That is a happy ending to my evening, thanks for the update on the old bus. Glad it's doing you and your clan a good turn! :)

  • Like 2
Posted

YES to the beige mats!

 

 

Old carpet runners or offcuts?  I did the same for the Safrane as I'm too mingebag to buy proper mats!

Posted

YES to the beige mats!

That is a happy ending to my evening, thanks for the update on the old bus. Glad it's doing you and your clan a good turn! :)

Yes, very pleased Joe :) I wish I'd bought one a while ago now.

Posted

Old carpet runners or offcuts? I did the same for the Safrane as I'm too mingebag to buy proper mats!

They're off cuts Rob, from the lounge carpet. They were only meant as a temporary fix but they work well actually! Probably better quality than most car mats.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...