Bren Posted August 30, 2023 Share Posted August 30, 2023 As my car never sold I thought I would spend some money on new plugs - my suspicions they had never been changed were confirmed when I pulled one last week. £70 lighter a set of bosch were obtained and I cracked on. Remember when Marlon Brando said " the horror - the horror" when his cork was popped in Apocalypse now? He was actually half way through changing a set of N62 plugs. To do the offside you need to move the header tank aside to give yourself more room. The plugs themselves are quite deep and you will need various extensions and a UJ. The coils came out after a struggle - various pry bars were needed to get them going. Due to depth at which the plugs sit you need to push them into a piece of rubber pipe ( I used fuel injection hose ) and wind them in until they start. You then pull the pipe free and use a socket to tighten. I put some red rubber grease around the boot. Some recommend dialectric grease in the coil but I doubt any moisture or corrosion could exist as the engine gets really hot. The plug being wound in. RayMK, CreepingJesus, Cavcraft and 3 others 6 Link to comment Share on other sites More sharing options...
Bren Posted August 30, 2023 Author Share Posted August 30, 2023 The rear was enough to have you reaching for the valium - I had to move the bracket for the aircon pipes and wiggle the coil underneath to get it out. My 5" extension was too long and I had to borrow a 3" one. Some posts on internet suggest moving the engine for better access. The nearside was a bit easier - move airbox for more access. Agiain all was ok until I got to the rear one - The plug is underneath the trunking from the DME - coil came out after a fight. New plug and it was all back together. As of yet I haven't tried the car - if there are any problems I will be leaving my shoes on the beach and doing a Reggie Perrin. It's one of those jobs nobody wants to do - access on a 6/7/X5 may well be better. Over two days it took me around five hours. My hands are mangled I am lucky I didnt lose a couple of finger nails. I can only assume whoever signed this off at BMW had been bin bagged by his missus the night before. Fingers crossed it starts. CreepingJesus, beko1987, Fraz and 5 others 7 1 Link to comment Share on other sites More sharing options...
sierraman Posted August 30, 2023 Share Posted August 30, 2023 If you are selling it at some point just do the easy ones. 😂 Link to comment Share on other sites More sharing options...
Bren Posted August 30, 2023 Author Share Posted August 30, 2023 Just now, sierraman said: If you are selling it at some point just do the easy ones. 😂 Ten years or 100k. They will not need replacing again. Link to comment Share on other sites More sharing options...
dome Posted August 30, 2023 Share Posted August 30, 2023 If you think that's bad wait til it needs rocker gaskets🙈 Link to comment Share on other sites More sharing options...
Bren Posted August 30, 2023 Author Share Posted August 30, 2023 1 minute ago, dome said: If you think that's bad wait til it needs rocker gaskets🙈 They were done when the valve stem seals were replaced. Thank fook. dome 1 Link to comment Share on other sites More sharing options...
SiC Posted August 30, 2023 Share Posted August 30, 2023 1 hour ago, Bren said: I can only assume whoever signed this off at BMW had been bin bagged by his missus the night before. Or won the internal BMW award for the most increase in servicing profit at dealers for long term owners. Link to comment Share on other sites More sharing options...
New POD Posted August 30, 2023 Share Posted August 30, 2023 1 hour ago, dome said: If you think that's bad wait til it needs rocker gaskets🙈 I've done both on a V6 omega plus the plugs twice. And the coil packs. To do the plugs, you have to remove the metal fuel pipes on one side and a mental cable tray on the other. Plus to unplug the coil packs requires magic fingers. To do the cam cover gaskets requires removing the inlet manifold. With seals that are NLS. But changing the spark plugs and coil packs stopped it throwing up engine codes. Stevebrookman 1 Link to comment Share on other sites More sharing options...
Bren Posted August 30, 2023 Author Share Posted August 30, 2023 The new plugs have made a world of difference. Car is much smoother and needs smaller applications of the throttle. mk2_craig, MiniMinorMk3, Vantman and 3 others 6 Link to comment Share on other sites More sharing options...
New POD Posted August 30, 2023 Share Posted August 30, 2023 I've just changed the plugs (and air filter) on my astra. Getting 44 mpg on the motorway where before I was seeing 40 mpg tooSavvy, Stevebrookman and Bren 2 1 Link to comment Share on other sites More sharing options...
jonny69 Posted August 31, 2023 Share Posted August 31, 2023 I did a learn. I didn’t know about the rubber hose spark plug trick Link to comment Share on other sites More sharing options...
Bren Posted August 31, 2023 Author Share Posted August 31, 2023 4 hours ago, jonny69 said: I did a learn. I didn’t know about the rubber hose spark plug trick w Why you need the hose - the plugs are quite deep. Link to comment Share on other sites More sharing options...
grogee Posted August 31, 2023 Share Posted August 31, 2023 What's an N62 in? (just so I can make a mental note never to buy one) Link to comment Share on other sites More sharing options...
Bren Posted August 31, 2023 Author Share Posted August 31, 2023 2 hours ago, grogee said: What's an N62 in? (just so I can make a mental note never to buy one) 5/6/7 and X5 Link to comment Share on other sites More sharing options...
Matty Posted August 31, 2023 Share Posted August 31, 2023 @Bren, can you link the for sale ad, can't find it by manually searching. Link to comment Share on other sites More sharing options...
RoverFolkUs Posted August 31, 2023 Share Posted August 31, 2023 Most BMW plugs are a nuisance, a shaved down socket and some locking wobbles/extensions make it easier Link to comment Share on other sites More sharing options...
jonny69 Posted August 31, 2023 Share Posted August 31, 2023 8 hours ago, Bren said: w Why you need the hose - the plugs are quite deep. I didn’t mean just for this. I can think of all sorts of things a bit of rubber hose will help me frustratingly wiggle something into a hole too tight to be fingering around in. EyesWeldedShut and Fraz 1 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now