Jump to content

Transport of project car, and clutch/gearbox problems...


Recommended Posts

Posted

So yesterday, things got a bit out of hand, and I ended up getting a Porsche 924s which I want but definitely don't need:

 

 

 

It doesn't drive, so my first problem is getting it transported. It's about 15 miles from where I live - any suggestions for companies in Derbyshire/Nottingham that are decent?

 

Also, it didn't want to go into gear with the engine off - and the clutch pedal goes down and doesn't rise again - any ideas with these? I've not worked on clutches/gearboxes before so need some pointers on where to start...

Posted

Yayyy! What a hero!

I just Google car transport, as long as it'll roll then it can be dragged onto a transporter.

Clutch issue will probably be the clutch slave cylinder.

I had one of these years ago, it was a good steer.

Posted

MOT says 10yr off the road...

 

Advisory: play in fwbrg (x2)

 

 

Bit 'o pezz and yrr away m8

 

 

WCPGW

 

 

TS

Posted

Happy to use the pumpkin to tow a trailer if you can blag one - will do for forum goodwill/karma

Posted

Serpent Motors in Chesterfield do car transporter and car trailer hire, if that's any help.

Posted

MOT says 10yr off the road...

 

Advisory: play in fwbrg (x2)

 

 

Bit 'o pezz and yrr away m8

 

 

WCPGW

 

 

TS

 

That'd be the dream! Sadly it needs a fair bit of work to get it in a decent state. Give me a couple of months...

 

 

Happy to use the pumpkin to tow a trailer if you can blag one - will do for forum goodwill/karma

 

Much appreciated, I can happily pay you with many beers. Do you think this would be ok on an A-frame? For that would it just need to be in neutral and have tyres in good nick? Can rent one of them off eBay for £25. No worries if it's too far out your way though - not sure where you're based but this would be Alfreton to Nottingham.

 

 

Serpent Motors in Chesterfield do car transporter and car trailer hire, if that's any help.

 

Just rung them - £120! For a journey of 15 miles it's a fair whack. Cheers for the suggestion though.

 

Any idea about it not going into gear even without the engine running? It seems to crunch into 1st and reverse but won't do any others. Unfortunately as it's not with me yet I can't do any more diagnosis!

Posted

What state is the gear linkage in? (assuming there is one on these) and also; how much oil is in the gearbox?

Posted

I had one of these (non S so cable clutch) where the clutch didn't clutch.

 

Turned out to be this little stub thing that the release bearing sits on (can't remember the name) that had gone the wrong shape and the release bearing got stuck in release.

 

Not sure if that helps you much.

 

Anyway the gear linkage on these is a big bar that goes to the back, I would check the oil in the box then maybe disconnect the linkage from the box end and see if you can select gears on the box with mole grips or whatever.

 

I'm sorry to report that getting the clutch out on these is a real sad job, the gearbox is best removed as there's no bend in the torque tube to get it off like you can on a normal rwd car with separate gearbag and diff.

 

Also access to the bellhousing bolts is non existent, as the engine is so tight against the bulkhead to achieve that legendary weight distribution.

 

Anyway, hope it turns out to be something easy.

  • Like 1
Posted

Just reread that the pedal goes down and stays down, think the S is a hydraulic clutch, so first check should be that it has some fluid in.

  • Like 1
Posted

It's not too far - I am only at J23 of the M1 - sounds like it could be a jolly jape.  I  am game for A framing it behind the crying pumpkin.

 

I reckon neutral and air in rear tyres should be OK as long as we don't go crazy with speed etc (we won't).

 

As for clutch/gears - I would imagine standing all that time's not been helping - it might all free off a bit with some rocking about.  I've know stuff that's been standing be a pig - clutches stuck on on the input shaft splines, etc, usually a bit of brute force and ignorance will help shift things :)

Posted

If you need extra brute force and/or ignorance I'm happy to help getting it rolling, although I've got nothing that can tow. I can optionally make encouraging sounds.

  • Like 3
Posted

Plus eleventy with add more hydraulic fluid.

My 944S had a similar issue with the pedal dropping to the floor and not bobbing back up again.

Posted

What state is the gear linkage in? (assuming there is one on these) and also; how much oil is in the gearbox?

 

Not too sure. I'll check that first though as hopefully it's that simple. I'll need to check at the gearstick end and at the gearbox end right?

 

 

 

It's not too far - I am only at J23 of the M1 - sounds like it could be a jolly jape.  I  am game for A framing it behind the crying pumpkin.

 

I reckon neutral and air in rear tyres should be OK as long as we don't go crazy with speed etc (we won't).

 

As for clutch/gears - I would imagine standing all that time's not been helping - it might all free off a bit with some rocking about.  I've know stuff that's been standing be a pig - clutches stuck on on the input shaft splines, etc, usually a bit of brute force and ignorance will help shift things :)

 

That'd be brilliant - I'll PM you.

Posted

Plus eleventy with add more hydraulic fluid.

My 944S had a similar issue with the pedal dropping to the floor and not bobbing back up again.

 

This sounds like a winner. I'm going back briefly on Saturday so I'll see if that's the issue! 

Posted

If you need extra brute force and/or ignorance I'm happy to help getting it rolling, although I've got nothing that can tow. I can optionally make encouraging sounds.

 

Autoshite Road Trip Adventure thing.

Posted

Stick a battery in it and try to start it - one of 2 things will happen

1 the clutch will unstick

2 the gearbox will explode into eleventy million bits

 

(there is a 3  now I think about it - nothing will happen)

  • Like 3
Posted

Stick a battery in it and try to start it - one of 2 things will happen

1 the clutch will unstick

2 the gearbox will explode into eleventy million bits

 

(there is a 3  now I think about it - nothing will happen)

Do this, and film the result!

Posted

 

 

 

 

 

 

 

 

 

 

Looking sexy after a wash.

 

Lots of electrics to fix. I've come to the conclusion that the gearbox is fine, but the clutch is fucked. Doesn't engage at all.

 

Brakes unseized by towing it, and the engine starts and runs ok! Gets hot though and the fan doesn't kick in so still a bit to do!

  • petermcpete changed the title to Transport of project car, and clutch/gearbox problems...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...