Jump to content
PhilA

1951 Pontiac Chieftain - Gearbox and wiring

Recommended Posts

Not much electrical works. It needs to be completely rewired because someone has "converted" it to 12V. Thankfully it was originally negative ground so that's a good start. Gauges and such can be driven from a 6V bucking converter.

 

--Phil

Car is ace

 

I hope that converter works or it might make for an interesting conversation down at the motor factors "have you got a bucking converter"............"I beg your pardon"..........."have you got a bucking converter"..........."and what does sir what the f***ing converter for"

Share this post


Link to post
Share on other sites

water pump, or convection cooling??? seem to remember the convection coolers had a hoooge pipe going to rad - as does the chief ;)

Share this post


Link to post
Share on other sites

Trailer booked for 11am tomorrow morning. That's, uh.. 5pm tomorrow UK.

 

post-5454-0-08674600-1535761375_thumb.jpg

 

Google reckons this route. On the way up I'll be on the Interstate but the way back is going to be highways only, methinks. I-55 is 22 miles of raised concrete bridge which is not even in the slightest, it likes to induce a pitching motion at 55 which I really do not fancy dealing with.

 

Gonna be fun...

 

 

Phil

Share this post


Link to post
Share on other sites

The Chieftain is kinda nose-heavy, but we were discussing uneven roadway and trailers whipping- at which point I asked if the wife would be happy towing mother in law's Fiat 500X, and she said yes. I said that's fine, the Chieftain is only 100lbs heavier than the Fiat.

Obviously the weight distribution is different. The Fiat is shorter nose to tail than the wheelbase of the Pontiac...

 

 

Old cars, etc etc.

 

Phil

Share this post


Link to post
Share on other sites

How cheap is your petrol?!?!

 

Chodspeed, my good fellow.

$2.509 /gal

 

So.. $0.68 /litre

 

That's for the standard dishwater. 87 octane with 10% ethanol. The ethanol is used to boost the fuel up to 87.

 

Thanks. It's due to rain rain rain tomorrow.

 

 

Phil

Share this post


Link to post
Share on other sites

First things first.

 

post-5454-0-04480900-1535807290_thumb.jpg

 

Coffee on, let's go do a last minute check on the tow vehicle. Today's weapon of choice: 2007 Chevrolet Silverado 1500 LT (5.3).

 

post-5454-0-60847700-1535807509_thumb.jpg

 

It's been sat up overnight so the level will be accurate.

 

post-5454-0-29995200-1535807561_thumb.jpg

 

That'll work.

 

post-5454-0-39565300-1535807605_thumb.jpg

 

Oh well. I guess it's right.

 

post-5454-0-99198600-1535807633_thumb.jpg

 

Welp, finalize prep in readiness to leave.

 

post-5454-0-52198200-1535807670_thumb.jpg

 

Shall be on the way shortly!

 

Phil

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Content

    • By dozeydustman
      Just about an hour ago I went to start my car up, had Mrs Dustman with me, to go and pick Miss Dustman up from work. Turned over fine but took a while to fire up.
       
      Steering felt heavy. Thought maybe as it's currently -5 + wind chill it's just cold & the fluid is thick.
       
      Started reversing out my bay then I was greeted with:
      "DING DONG" - ABS fault.
      "DING DONG" - ESP fault
      "DING DONG" - headlamp auto levelling not working, contact service.
       
      I shut the car down straight away and we went in Mrs D's Corolla.
       
      Alternator is less than 2 months old, it's a recon unit from Alternator Man in Portsmouth. Hoping the cold isn't killing the battery and it's taking the 'nator out with it (battery passed the drop test last time the no-charge warning came up). Looks like a session with the multimeter after work tomorrow.....
       
      MEH.
    • By dozeydustman
      Mrs Dustman has a dash cam she wants me to fit to her '99 frog face Corolla. It came with a hard wire kit as opposed to the usual fag lighter lead, so I might as well make a decent* job of it and hide the wiring completely. Trouble is I can't remember how I got the radio pod out when I fitted the DAB unit she now has. I've also got a few dash illumination bulbs to change so I might as well do it all in one hit while it's a sunny afternoon.
       
      A bit of googling comes up with the US spec dash which appears to be different from the European model, or the 2002-on model. I seem to remember spudging out the dash vents to access some bolts/rivets.
       
      Failing that, is there an easier place to get a switched live from (besides the radio) that doesn't involve destroying the car's interior?
    • By 1970mgb
      So, someone posted on another thread a link to an Ebay listing for an LHD '74 Marina listed on Ebay.
      I called a little while ago and talked to the seller, and the story is that it was a good running and driving car 10 years ago, but has been neglected and won't run. I'm debating with myself about whether or not I want to take it on as a project.
      I know these had a terrible reputation when new, but at the same time they're actually legitimately rare in the US. I have seen one in person, and most of the estimates I've seen put the number of survivors at 10-20(although I don't know how much we can trust that).
      There's some definite appeal in the engine familiarity for me with the MGB. I MIGHT have to convert it to a manual though. In addition, there's the issue of having it shipped a couple hundred miles to me. It's listed now for $700...if I could do $500 it might be a make or break for me.
      Any thoughts here on it?
       
      EDIT: The car as it sits now is an automatic. If I swapped the transmission, it would be to a manual. Sorry for any confusion from my incorrect statement!
    • By blackboilersuit
      After many a long year of occasional contribution on here I've probably got enough old shite on fleet now to do something I should have done yonks ago and start a project thread.
      The story so far.........
      I had an 02 CRV for 6 years and it performed faultlessly as an car taking everything in it's stride. The only issue with it was the 25mpg it returned but as I worked close to home that wasn't an issue. Cue December last year and a new job saw my commute go up from 4 miles a day to 32 miles a day.

      By March I was drowning in green shield stamps so  bought the mighty diesel disAstra from Davehedgehog of this here parish. Shown here on the only off-road parking and only second car parking space I have. The garage contains a few motorbikes so I've always stubbornly stuck to a single car rule so I don't have to move motors to get bikes in and out. More on this detail in a bit.....

      A combination of broken motorcycles needing worked on, a bike trip around the Baltic and work meant that I soon realised that I had no time to prep the disAstra for its MOT  at the start of this month. It wasn't worth enough to pay to have the work done so I decided that the poor old thing would be scrapped in favour of a replacement motor.........
      The mighty Volvo (V70 D5) was purchased from Ma & Pa forddeliveryboy of this parish and migrated north of the border back to it's natural home.

      Three days after being pressed into commuting service the mighty volvo suffered a (badly) sticking caliper and much burning brake smells that had to be stripped and rebuilt before work the next day. Sticking piston at that so the whole thing was off and the brakes had to be bled afterwards. Two and a half hours in the pissing rain was a bit character building especially as the still MOT'd (by 3 days) and taxed (but not insured) astra was sitting on the drive. Decision made, insurance checked and a soon to be taken out Admiral multi-car policy will see me with two cars on the fleet again. I could have used one of the bikes but motorway commuting in the pissing rain on two wheels is no fun. The volvo needs an MOT in december so having the astra back on the road will take the pressure off getting that done if it needs work and the weather is bad.
      And so as the volvo continues to provide daily service, project astra revival starts. Known MOT work needed is frilly arches,  broken number plate and front discs and pads so nothing major. Thus far the arches have been sorted without resort to duct tape.
      After a bit of prodding.......

      And after the angle grinder was let loose surprisingly it was only the return lip that was rotten so the welder was broken out to lash on some roughly cut fresh metal.

      Linished off filled, sanded and primed. Note the use of a farmfoods brochure pulled out the bin being used as masking paper for extra shite points.

      Followed by a near perfect colour matched (*) top coat....

      Well I had black on the shelf and it's good enough to stop the primer soaking up the water so that'll do for now.
      Hoping to get brakes and MOT sorted in the coming week so more to follow soon (hopefully).
×
×
  • Create New...