Upper gearbox rubber was replaced at the same time as the main top engine mount. I thought the dog bone was ok too so didn't change it. I didn't know there was another mount and can't quite place it from the picture.
Both Me and Neil were discussing this the other day as it is quite a bit (a lot) faster the the current shit 182 that arrived.
Have you a friendly tester for the decat pipe?
I also didin't realise there was another mount, which is why I thought the dogbone was the fault. This mount is at the front of the box, and bolts to the subframe.
I'm considering having a dyno run, just out of curiosity, because there's a small optimistic part of me that think ot may have fast cams in it, hence the lumpy idle, and would really ,ove to see a good figure.
Hopefully, I can get it tested sans cat. If not, I'll probably see about getting a cheap used one for the test.